Edge-lighting Scope LED Pendant Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Iluminação Edge-lighting Scope LED Pendant. Edge Lighting Scope LED Pendant User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 3
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
FJ-SCLP-_
Installation Instructions for Fast Jack Scope LED Pendant
1
904-FJ-SCLP-05
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2011 Edge Lighting. All Rights Reserved.
B
M4 SET SCREW
M3 SET
SCREW
1.5MM ALLEN
WRENCH
2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE CONNECTOR
Adjust the Fixture Height
A
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the metal shade to the end of the coaxial cable.
H
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
1
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- The product is intended to be used with Edge Lighting
Monorail systems only.
- The product is safe to be used in food processing or
consuming areas without the glass lens. It is safe to use
the thermoplastic lens in the fixture. For more information
see "Adjusting the Light Beam" section.
IMPORTANT INFORMATION
4: Feed the coaxial cable through the conical nipple and flared
side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.
C
CONICAL
NIPPLE
STRAIN RELIEF TUBE
COAXIAL CABLE
4
D
COAXIAL CABLE
5
5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.
Vista de página 0
1 2 3

Resumo do Conteúdo

Página 1 - Fast Jack Scope LED Pendant

FJ-SCLP-_Installation Instructions for Fast Jack Scope LED Pendant1904-FJ-SCLP-051718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5

Página 2 - CIRCUIT #2

2 9: Push the strain relief tube completely into the coaxial fixture connector. Make sure the slot on the strain relief tube is not inlin

Página 3 - Install the Crystal Accessory

HMETAL SHADEI3Adjusting the Light Beam & Intensity1: Rotate the lens housing (inside the fixture body) and set the beam spread to either spot

Comentários a estes Manuais

Sem comentários