Edge-lighting LED Canopy Mount Transformer Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Iluminação Edge-lighting LED Canopy Mount Transformer. Edge Lighting LED Canopy Mount Transformer User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
SAVE THESE INSTRUCTIONS!
MTE-60L-12-_
- This product is ETL listed for indoor dry locations.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
- This product should be installed by a qualified electrician.
B
5: Connect each low voltage wire transformer to one power
feed canopy wire with a wire nut.
Installation Instructions for Monorail 4" Round Single Power Feed
Canopy with 60 Watt 12 Volt Electronic LED Transformer
Install the Electronic Transformer & Canopy
1
904-MTE-60L-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
5
NOTE: Use the universal round crossbar (provided) if the electrical
box holes are not spaced 2-3/4" apart.
5
© 2012 Edge Lighting. All Rights Reserved.
A
1: Turn the power to electrical box off.
2: Connect the white transformer wire to the neutral power
wire with a wire nut.
3: Connect the black transformer wire to the hot power wire
with a wire nut.
4: Place the transformer and transformer wires inside the
electrical box.
TRANSFORMER
2
3
C
7
#8-32
SCREW
6: Place all wires inside the electrical box.
7: Secure the power feed canopy to the electrical box by
tightening the two provided #8-32 screws with the 3/32
Allen wrench.
3/32 ALLEN
WRENCH
7
6
4
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - IMPORTANT INFORMATION

SAVE THESE INSTRUCTIONS!MTE-60L-12-_- This product is ETL listed for indoor dry locations.- This product can be installed to a 4" electrical box

Página 2

DCAP3/8-24 SET SCREWPOWER HOUSING213/16 ALLEN WRENCHCAP21: Unscrew the cap from power housing.2: Slightly loosen the 3/8-24 set screw on the cap with

Comentários a estes Manuais

Sem comentários