Edge-lighting Step Manual do Utilizador descarregar pdf (Página 4)

12: Feed the pigtail wires through the cover hole and mount to

cover to the housing with the four #8-32 screws.

13: Repeat step 12 for the remaining housings.

COVER

#8-32 SCREW

Install Drywall, Trim & Lamp

1: Mark 3" square(s) on drywall where the housing opening is

(are) located.

2: Cut out the marked square(s) and install the drywall.

3: After installing drywall and finishing it, connect each wire coming out of the housing opening to one trim wire with a wire nut.

4: Place all wires inside the housing and gently push the trim into the housing opening by squeezing the side springs.

5: (Optional) - If slave housings are used, then repeat steps 3 and 4 for all slave housings.

DRYWALL

TRIM

6: Pull the trim cover off to expose the socket.

7: Push the lamp pins completely into the socket holes.

8: Replace the cover to the trim.

9: (Optional) - If slave housing are used, repeat steps 6

through 8 for all the housings.

CAUTION: To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

Use MAX 10 Watt Bi-Pin Halogen Lamp For Each Socket.

NOTE: Use only fingers and a soft cloth to install the lamps.

Use MAX 10 Watt Bi-Pin Halogen Lamp For Each Socket.

SOCKET

TRIM

COVER

LAMP

1 2 3 4

Sem comentários

Edge-lighting Step Manual do Utilizador Página 4