Edge-lighting 17 Port Linear Canopies Without Transformers Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Iluminação Edge-lighting 17 Port Linear Canopies Without Transformers. Edge Lighting 17 Port Linear Canopies Without Transformers User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
FJC-33RE-_
Installation Instructions for 14 or 17 Port Rectangle Fast Jack
Canopy Only
904-FJC-33RE-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2012 Edge Lighting. All Rights Reserved.
1
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
Running the Power from a Remote Transformer to the
Fast Jack Canopy
A
1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.
REMOTE
TRANSFORMER
ELECTRICAL BOX
CONDUIT
MAX
20FT
FAST JACK
CANOPY
1
Install the Canopy
B
MOUNTING PLATE
CANOPY
#8-32 SCREW
1
1
1: Remove the fourteen #8-32 screws around the canopy to
remove the mounting plate.
C
MOUNTING PLATE
#8-32 SCREW
3
2
3
2:
Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.
Feed the power wires through mounting plate center hole.
3:
NOTE: It is recommended that a person to hold the mounting
plate while the electrician installs it.
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - Canopy Only

FJC-33RE-_Installation Instructions for 14 or 17 Port Rectangle Fast Jack Canopy Only904-FJC-33RE-01IMPORTANT INFORMATION1718 W. Fullerton AveChicago

Página 2

24: Tap the anchors through the mounting plate holes onto the marked point up to the threaded portion with a hammer.5: Screw in the threaded porti

Comentários a estes Manuais

Sem comentários