Edge-lighting Reflection Manual do Utilizador descarregar pdf (Página 2)

5: Feed the power wires through the mounting plate center

hole.

6: Line up the mounting plate holes with the anchors and

secure it to the anchors with the six #8-32 screws provided.

7: Make sure that the mounting plate is grounded in

accordance with local electrical codes.

8: Connect the white fixture wire to the neutral power wire

with a wire nut.

9: Connect the black fixture wire to the hot power wire with a

wire nut.

Install the Lamp & Mirror

LAMP

SOCKET

MOUNTING PLATE

THUMB

SCREW

MIRROR

1: Push the lamp pins completely into the socket holes and

secure by snapping into the spring clips. Repeat this step

for the remaining sockets.

2: Place the mirror housing into the mounting plate and secure

it in place by tightening the two thumb screws on the top

and bottom of the mounting plate into the mirror housing.

POWER

LINE

6 6

CAUTION: To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

Use MAX 55 Watt Type 2G11 Base

Compact Fluorescent Lamp For Each Socket.

MOUNTING PLATE

CENTER HOLE

SPRING CLIP

NOTE: NEMA fluorescent lamp manufacturers recommend to

reduce possible flicker or instability when new dimming systems

are comissioned, lamps should be operated at the ballast's

maximum light output setting overnight (approximately

12 hours).

1 2

Sem comentários

Edge-lighting Reflection Manual do Utilizador Página 2